✨ What You'll Learn in This Video: ✔️ Correct positioning of hair topper whilst washing ✔️ Step-by-step instructions for a quick and thorough clean ✔️ Tips to avoid damage and preserve the quality
Aftercare
The correct after care is paramount to keeping your wig or hairpiece in tip top condition throughout its life. If you are unsure of anything mentioned below, please do not hesitate to get in touch.
Whats Needed:
Step 1: Detangle the Wig
Gently comb through the wig with a wide-tooth comb to remove any tangles or knots. Start from the tips and work your way up to the roots. Hold the wig at the base to prevent unnecessary tension on the hair.
Step 2: Prepare the Washing Solution
Place the wig under a gentle stream of lukewarm water in the shower or under a tap. Wet the hair thoroughly.
You are able to immerse a short fibre wig into a bowl/sink of water, however after this has soaked, please follow the next instructions.
Step 3: Apply Shampoo.
Apply a small amount of mild sulfate-free shampoo directly to the wet hair. Gently massage the shampoo into the hair, following the direction of the water flow. Pay attention to the cap and areas that may have accumulated oils or styling products. Avoid rubbing or twisting the hair.
Step 4: Rinse Thoroughly
Allow the water to flow over the wig, rinsing out the shampoo. Ensure all the shampoo is washed out, following the direction of the water flow. Gently shake the wig to release excess water. Repeat 2 times if the wig has a build up of oils or product.
Step 5: Apply Conditioner
Apply a small amount of conditioner to the wet hair, avoiding the wig cap. Use your fingers to distribute the conditioner evenly through the strands, following the water flow. Leave the conditioner on for the recommended time, usually 5-10 minutes.
Step 6: Gently Brush with Wig Brush or wide toothed comb
While the conditioner is still in the hair, use a wig brush to gently detangle. Hold the cap to prevent pulling any hairs out and brush through the ends with the conditioner on. Start from the tips and work your way up to the roots.
Step 7: Rinse Again
Under the gentle stream of water, rinse the wig thoroughly to remove all traces of conditioner. Ensure that there is no residual product left in the hair, following the direction of the water flow.
Step 8: Towel Patting
Place the wig on a clean towel and pat it gently to remove excess water. Avoid wringing or twisting the wig, as this can cause damage.
Step 9: Air Dry or Blow Dry
Place the wig on a wig stand or mannequin head to air dry. Comb or brush out gently. Avoid using heat styling tools or exposing the wig to direct sunlight while it's wet. Make sure the wig is completely dry before using heat tools ( For human hair only).DO NOT use heat tools or hair dryers on synthetic hair.Be wary with heat tools on human hair, especially blondes, carry out a test piece first.
Step 10: Comb and Style
Once the wig is dry, use a wide-tooth comb to gently detangle the hair. Style the wig as desired, and you're ready to wear it again.
Additional Tips:
Copyright © 2025 Vicki-Jane Hair Design All Rights Reserved.